Volkswagen Touran Owners Manual: Fitting the front towing eye
Fig. 227 Front bumper, right-hand side: screwing in the towing eye
First read and observe the introductory information
and safety warnings The towing eye is screwed into a threaded hole on the right of the front bumper .
The towing eye must always be kept in the vehicle.
Observe the notes on tow-starting .
Fitting the towing eye at front
- Take the towing eye and screwdriver out of the tool set in the luggage compartment .
- Pull the cover in the lower part of the bumper forwards and leave it hanging from the vehicle.
- Turn the towing eye anti-clockwise into the threaded hole and tighten as far as possible . Use a suitable object to screw the towing eye fully and securely into the mounting.
- When you have finished towing, turn the towing eye clockwise to remove it and fit the cover.
NOTICE
Notes on towing
First read and observe the introductory information
and safety warnings Tow-rope or tow-bar
It is easier and safer to tow a vehicle with a tow-bar. Only use a tow-rope if
you do not have a tow- ...
Fitting the rear towing eye
Fig. 228 Rear bumper, right-hand side:
screwing in the towing eye
First read and observe the introductory information
and safety warnings The towing eye is screwed into a threaded hole on the ...
Other materials:
Volkswagen Touran Service Manual. Run-Flat Tire, Structure and Identification, SST Tire
Run-Flat Tires, Dismounting and Mounting. Refer to
→ Chapter "Tires, Mounting".
A Tire Pressure Monitoring Display is Necessary When Using
Run-Flat Tires.
Tire Damage and the Pressure Loss Resulting From it is ...
Volkswagen Touran Service Manual. Wire Break with Dual Repair Point
Repair point with intermediate wire section
Free up wire intended for repair at two points
(approximately 20 cm to both sides of respective repair points).
If required, remove wiring harness wrapping ...
