Volkswagen Touran Service Manual: Tires and Rims, Matching
| If necessary repair flat spots from standing. Refer to
→ Chapter "Flat Spots, Correcting". |
| |
Dismount the tire. Refer to
→ Chapter "Tires, Dismounting". |
| |
Turn the tire about 180 against the rim. |
| |
Inflate the tire to 4 bar (58 psi). |
| |
Tension the wheel with the tire on the balancing machine. |
| |
Check the tire and wheel radial and lateral run-out. Refer
to
→ Chapter "Wheel, Balancing, Tire and Wheel Radial and Lateral
Run-Out, Checking". |
| |
If the radial and lateral run-out are within the specified
values, balance the wheel to 0. Refer to
→ Anchor. |
| |
If the radial and lateral run-out are outside the specified
values, match the tire and rim again and rotate the tire 90
relative to the rim. |
| |
Check the tire and wheel radial and lateral run-out again.
Refer to
→ Chapter "Wheel, Balancing, Tire and Wheel Radial and Lateral
Run-Out, Checking". |
| |
If the radial and lateral run-out are within the specified
values, balance the wheel to 0. Refer to
→ Anchor. |
| |
If the radial and lateral run-out are outside the specified
values, match the tire and rim again and rotate the tire 180
relative to the rim. |
| |
Check the tire and wheel radial and lateral run-out again.
Refer to
→ Chapter "Wheel, Balancing, Tire and Wheel Radial and Lateral
Run-Out, Checking". |
| |
If the radial and lateral run-out are within the specified
values, balance the wheel to 0. Refer to
→ Anchor. |
| |
If the radial and lateral run-out are still outside the
specified values check the rim for radial and lateral run-out.
Refer to
→ Chapter "Wheel Balancing, Rim Radial and Lateral Run-Out,
Checking". |
| |
In the radial and lateral run-out of the rim is within the
specified values, replace the tire. |
|
|
|
Only trained personnel can perform the assembly work on
run-flat tires and ultra high performance tires.
If equipped check the tire pressure mo ...
Other materials:
Taper
Taper is caused by slightly offsetting the tread and/or the
belt by a few tenths of a millimeter from the geometric center
of the tire. Taper cannot be recognized visually nor can it be
measured with workshop equipment.
...
One-Part Test Paint
Definition:
One-Part Test Paint -LLS MAX 005-, black
Edition 10/2008
Product Description
The One-Part Test Paint -LLS MAX 005- is a single-compound
product from the NC resin ...
After changing a wheel
First read and observe the introductory information
and safety warnings
If needed, clean the tools then place them back in the foam rubber holder
in the luggage compartment or behind the side trim on the left-hand side of
the luggage compartment
Stow the spare wheel, temporar ...
© 2016-2019 Copyright www.vwtouran.net
Tires, Mounting, Run-Flat Tires and Ultra High Performance Tires
Wheel, Balancing