Volkswagen Touran Owners Manual: Vents

Volkswagen Touran Owners Manual / While driving / Air conditioning system / Heating, ventilating, cooling / Vents

Fig. 162 In the dash panel: vents

Fig. 163 In the rear section of the centre console: vents for rear ventilation

First read and observe the introductory information and safety warnings

Vents

To ensure that the vehicle interior is sufficiently heated, ventilated and cooled, you should never fully close the vents , .

Turn the thumb wheel in the required direction to open and close the vents.

Adjust the direction of the air flow by moving the grille.

Further vents can be found in the footwell and in the rear area of the vehicle interior.

NOTICE

Do not place any food, medicine or any other heat-sensitive items in front of the air vents. Heat-sensitive food, medicine and other items could be either damaged or rendered useless.

The air from the outlets flows through the passenger compartment and out of the vehicle through the slots below the rear window. The slots must not be covered by items of clothing or other items.

Information on the air conditioning system

First read and observe the introductory information and safety warnings The cooling system for the vehicle interior only works when the engine is running and the blower is switched on. The air ...

Air recirculation mode

First read and observe the introductory information and safety warnings General notes There are different types of air recirculation mode: Man ...

Other materials:

Volkswagen Touran Owners Manual. Net partition
Fig. 100 A: Folding out the net partition ①, ② B: Folding back the net partition ③, ④ Fig. 101 A. Net partition installed behind the second row of seats B: Net partition installed behind the front seats First read and observe the introductory information and safet ...

Volkswagen Touran Service Manual. Aqua Premium Application Instructions for Water-Soluble Products
When working with water-soluble products, pretreat the base surface very carefully and only with water-soluble products and the recommended processing materials. Base Surface Pre-treatment of base surfaces: ...