VW Touran manuals

Volkswagen Touran Owners Manual: Warning lamps

Fig. 51 Warning lamp in the instrument cluster

First read and observe the introductory information and safety warnings
Lights up or flashes Possible cause Correction
The driver and front passenger seat belts are not fastened (if the front passenger seat is occupied). Fasten seat belts.
There are items on the front passenger seat. Remove items from the front passenger seat and stow them safely.

Several warning and indicator lamps will light up briefly when the ignition is switched on while the vehicle runs functional checks. They will switch off after a few seconds.

An audible signal will be emitted for some seconds if the seat belts are not fastened as the car pulls off and reaches a speed of more than 25 km/h (15 mph) or if the seat belts are unfastened while the vehicle is in motion. The seat belt warning lamp will also flash .

The seat belt warning lamp does not go out until the driver and front passenger fasten their seat belts while the ignition is switched on.

WARNING

Incorrectly fastened or unfastened seat belts increase the risk of severe or fatal injuries. Seat belts will only offer the optimum level of protection when they are used properly.
    Introduction
    This chapter contains information on the following subjects:  → Warning lamps    → Frontal collisions and the laws of physics    → What happens to pass ...

    Frontal collisions and the laws of physics
    Fig. 52 Passengers of a vehicle heading for a brick wall. They are not wearing seat belts Fig. 53 A vehicle with unbelted occupants strikes the wall First read and observe the introductory inf ...

    Other materials:

    Volkswagen Touran Owners Manual. Introduction
    This chapter contains information on the following subjects:  → Preparing for a journey and driving safely    → Driving abroad    →  Driving through water  Depending on where the vehicle is used, it could be a good idea to have an engin ...

    Volkswagen Touran Service Manual. Run-Flat Tire PAX, Examining
    Pay special attention to the following criteria when examining the tire: Surface erosion or marbling on the inner side (pressure was too low or insufficient for the load)     ...

    © 2016-2019 Copyright www.vwtouran.net | 0.0058