Volkswagen Touran Service Manual: Charging Systems not Requiring a Permit

Volkswagen Touran Service Manual / Heating, Ventilation and Air Conditioning / Refrigerant Circuit General Information / A/C Service and Recycling Units / Charging Systems not Requiring a Permit

At this time, A/C service units for extracting, cleaning and filling refrigerant for motor vehicle A/C systems are available from various manufacturers.

Charging systems not requiring a permit are ones used for transferring compressed gases to mobile compressed-gas vessels for internal use only.

Note:

Some A/C service units are charging systems not requiring a permit. When working with such equipment, the refrigerant is not transferred to mobile compressed-gas vessels, but rather into a permanently installed charging cylinder with visible level gauge and float switch.

Recommendation:

It is advisable to use a portable cylinder with visible level gauge and pressure relief valve for surplus refrigerant for internal use.

Observe the different technical regulations for handling and filling compressed gases in other compressed-gas vessels (for example RGS 400, TRGS 402, TRGS 407, TRGS 510, TRBS 3145 / TRGS 725).

Extraction System Group Classifications

At this time, A/C service units for extracting, cleaning and filling refrigerant for motor vehicle A/C systems are available from various manufacturers. ...

Refrigerant Circuit Repair Information

WARNING When performing work on refrigerant circuit, observe all generally applicable safety precautions and pressure ...

Other materials:

Volkswagen Touran Service Manual. Tires, Aging
Even tires that look in good shape, new or hardly use and have sufficient tread depth and that are older than 6 years, can age caused by moisture and winter conditions. Tire test show that through continual development, new rubber ...

Volkswagen Touran Service Manual. Aerial Cable Repair Set -VAS6720-
Special tools and workshop equipment required Repair Set, Aerial Cable -VAS6720- Checking the Antenna Wire. Refer to Replacing the Tool Head. Refer to Cutting the Antenna W ...