Volkswagen Touran Service Manual: Adhesive Surface Pretreatment when Replacing Laser-Soldered Roofs
|
Dry sand the cataphoretic primer on the roof adhesive
surface -item 6-
→ Item down to the bare metal using P180 sandpaper. |
|
|
|
|
Dry sand the roof pillar adhesive surface
-item 6-
→ Item down to the bare metal using P180 sandpaper. |
Note
Prime the sanded-through areas outside of the body adhesive
-item 6-
→ Item with Two-Part Wash Primer - LHV 043 000 A2-
and then fill with Two-Part HS Performance Filler. |
|
Clean the adhesion area with Silicone Remover. |
|
Replace the roof. Refer to
→ Body Exterior; Rep. Gr.51. |
|
|
|
1 - |
Two-Part Window Adhesive |
4 - |
Two-Part Body Adhesive |
5 - |
Roof Pillar/Side Panel |
6 - |
Sanded-Down Bare Metal Area |
Note
The underbody and stone chip protection structure must be
restored back to its original layer strength and appearance
during a repair.
...
Note
The corrosion protection in the fender seam must be applied on all
replacement parts, on which the attached seal is not already present.
The additional corrosio ...
Other materials:
Volkswagen Touran Owners Manual. Service interval display
First read and observe the introductory information
and safety warnings The service display is shown on the instrument cluster
.
Service schedules at Volkswagen are divided into two categories, with
oil change, e.g. interval service, and without oil change, e.g. inspection
service. Th ...
Volkswagen Touran Owners Manual. Engine oil specification
First read and observe the introductory
information and safety warnings The engine oil used must correspond
exactly to specifications.
The correct engine oil is important for the function and service life of the
engine. A special high quality multigrade oil has been filled at the factory an ...
© 2016-2024 Copyright www.vwtouran.net | 0.024