Volkswagen Touran Service Manual: Battery, Testing using Midtronics Battery Tester -MCR340VKT-

Volkswagen Touran Service Manual / Electrical System / Battery, Starter, Generator, Cruise Control / Battery, Checking / Battery, Testing using Midtronics Battery Tester -MCR340VKT-

Requirements

WARNING

Read and follow the Safety Precautions when working with batteries. Refer to → Chapter "Warnings and Safety Precautions".

Batteries that have a light yellow visual indicator do not have to be tested or charged. Jump starting must not be used!

There is a risk of explosion during testing, charging or jump starting.

These batteries must be replaced.

Read the General Description. Refer to → Chapter "General Information".

Visually check the battery. Refer to → Chapter "Visual Inspection".

Open the hood or open the cover if the battery is installed somewhere else.

Determine if it is a "Standard" battery or an "AGM" battery.

Remove the covers on the battery positive and negative terminals.

Use a fender protector or some type of cover before using any equipment inside the engine compartment or inside the passenger compartment.

Close all the doors.

Note

The battery temperature must be at least 10 C (50 F).

Refer to the Battery Tester Charger Kit -VASRX3000- Operating Instructions for more information.

Performing the Test

WARNING

Batteries that have a light yellow visual indicator do not have to be tested or charged. Jump starting must not be used!

There is a risk of explosion during testing, charging or jump starting.

These batteries must be replaced.

Turn off the ignition and all electrical consumers.

Check the visual indicator. Refer to → Chapter "Battery with Visual Indicator, Checking".

Switch on the unit.

Clamp the red clamp "+" of the tester to the positive terminal.

Clamp the black clamp "-" on the tester to the negative terminal.

Note

Make sure the test clamps make good contact!

Select "inside the vehicle" or "outside of the vehicle".

Select "Warranty Test".

Note

If the test results are needed to process a warranty claim, use the print function on the Midtronics Battery Tester -MCR340VKT-.

Determine if it is a "Standard" battery or an "AGM" battery.

Enter the battery DIN value taken from the battery label. If the label does not state a DIN value, then enter the SAE value.

Enter the DIN value into the tester and then perform the battery test. Refer to MCR340V Operating Instructions.

If using an SAE value, go into the menu under "other" and change "DIN" to "SAE". Refer to MCR340VKT Operating Instructions.

Note

Always use the DIN value on the battery label. Otherwise the test result will be incorrect.

Evaluating Test Results

Battery Test Result

Battery Test Result	Measure
Battery good	None
Good - charge	Charge battery. Refer to → Chapter "Battery Tester Charger Kit -GRX3000VAS-".
Use in charge	Charge battery. Refer to → Chapter "Battery Tester Charger Kit -GRX3000VAS-".
Replace the battery.	Replace the battery. Refer to → Electrical Equipment; Rep. Gr.27
Battery cell defective	Replace the battery. Refer to → Electrical Equipment; Rep. Gr.27

Midtronics Battery Tester -MCR340VKT-, Troubleshooting

Sometimes the display shows the malfunction or the messages based on the condition.

The following is a list of the most frequent displayed messages together with suggested solutions.

Note

Refer to the MCR340V Operating Instructions for messages not listed here.

Display Message

Measure

No display

Make sure the battery tester terminals are attached securely to the battery terminals.

Make sure the battery pole is tightened to the tightening specification and is not corroded.

Charge battery. Refer to → Chapter "Battery Tester Charger Kit -GRX3000VAS-".

System noises

Switch off all electrical consumers.

Wait until all electrical equipment, which are monitored by the vehicle electrical system control module, are switched off.

Remove the key.

Disconnect any doubtful or standard production electrical equipment from the vehicle electrical system.

Wait a few minutes and then perform the test again. Refer to → Chapter "Battery, Testing using Midtronics Battery Tester -MCR340VKT-".

Note

If the test was performed at the battery jump start terminal and the message still does not go away, then perform the test directly on the battery.

General Information

WARNING Risk of injury. Read and follow the Safety Precautions when working with batterie ...

Current Draw Test

WARNING Batteries that have a light yellow visual indicator do not have to be tested or charged. Jump starting must ...

Other materials:

Volkswagen Touran Owners Manual. Checking the electrolyte level of the vehicle battery
Fig. 179 In the engine compartment: removing the battery cover Fig. 180 Engine compartment: pushing up the vehicle battery sleeve First read and observe the introductory information and safety warnings The electrolyte level of the vehicle battery should be checked regularly in high-mil ...

Volkswagen Touran Service Manual. HS Spot Thinner
Definition: HS Spot Thinner -LVM 006 000 A2- Edition 06/2013 Product Description HS Spot Thinner -LVM 006 000 A2- is a special drying accelerator for minor repairs in certain ...