Volkswagen Touran Service Manual: Contact Release Tools

Volkswagen Touran Service Manual / Electrical System / Wiring / Wiring Harness and Connector Repairs / Contact Release Tools

Various release tools are used to remove the different terminals from terminal housings without damage.

A selection of release tools are a component of the Wiring Harness Repair Set -VAS1978- and the Wiring Harness Repair Set -VAS1978A-. The Release Tool Set -VAS1978/35- contains the entire set of release tools. Refer to → Chapter "Release Tool Set -VAS1978/35-".

WARNING

Some tools are supplied with a tool safety clip, which is slid over the tool points after using the tool, in order to protect other workers from injuries and tool points from damage.

Contact housings, releasing and disassembling. Refer to → Chapter "Contact Housings, Releasing and Disassembling".

Crimping Pliers with Insert

The Crimping Pliers without Insert -VAS1978/1- with Crimping Pliers - Insert 2 -VAS1978/2- is a component of the Wiring Harness Repair Set -VAS1978- and is used to cr ...

Single Wire Seal Assembly Tools

Assembly tools serve the purpose of allowing the single wire seals to be slid without damage into terminal housing up to stop, this achieves a complete seal between s ...

Other materials:

Volkswagen Touran Owners Manual. Overview of the front passenger side
Fig. 10 Overview of the front passenger side (left-hand drive vehicles). The controls are mirrored for right-hand drive vehicles Key for : Location of front passenger front airbag in the dash panel Key-operated switch in the stowage compartment for switching off the front passen ...

Volkswagen Touran Service Manual. Tires, Mounting, Wheels without and with Tire Pressure Monitoring System
Only trained personnel can perform the assembly work on run-flat tires. If equipped check the tire pressure monitoring sensor with the vehicle diagnostic tester and if necessary replace. Bring the tire ...