VW Touran manuals

Volkswagen Touran Owners Manual: Driving with an automatic gearbox

First read and observe the introductory information and safety warnings

The gearbox changes the forward gears up and down automatically.

Driving down hills

The steeper the gradient, the lower the gear you will need. Lower gears increase the braking effect of the engine. Never allow the vehicle to roll down mountains or hills in the neutral position N.

Stopping the vehicle and pulling away when driving uphill

The steeper the incline, the lower the gear you will need.

If you wish to stop the vehicle or pull away when driving uphill, you should use the Hill Hold assist function   .

Vehicles without Hill Hold assist: When you stop the vehicle on an incline and the vehicle remains in gear, the vehicle must always be prevented from rolling by depressing the brake pedal or by applying the handbrake. The brake pedal or the handbrake should not be released until you start to pull away  .

Kick-down

The kick-down mechanism enables maximum acceleration in the selector lever position D, S or in the Tiptronic position.

If the accelerator pedal is depressed fully, the gearbox will automatically shift to a lower gear, depending on speed and the engine revs. This will make use of the full vehicle acceleration  .

The gearbox does not shift up to the next gear until the engine reaches the maximum engine speed for the gear.

WARNING

Rapid acceleration can cause loss of traction and skidding, particularly on slippery roads. This could cause you to lose control of the vehicle, causing accidents and serious injuries.

NOTICE

Changing gear using Tiptronic
Fig. 134 Selector lever in Tiptronic position (left-hand drive). Mirror image for right-hand drive vehicles Fig. 135 Steering wheel with two paddles for Tiptronic First read and observe the in ...

Fault in the function of the automatic gearbox
First read and observe the introductory information and safety warnings Emergency programme There is a fault in the system if all the displays on the instrument cluster for the selector lever ...

Other materials:

Volkswagen Touran Service Manual. Adhesive Surface Pretreatment when Replacing Laser-Soldered Roofs
  Dry sand the cataphoretic primer on the roof adhesive surface -item 6- → Item down to the bare metal using P180 sandpaper.     Dry sand the roof pillar adhesive surface ...

Volkswagen Touran Service Manual. Threaded Connections, Repairing
Special tools and workshop equipment required Torque Wrench 1331 5-50Nm -VAG1331-   Note Do not use rust remover, contact spray or grease because the lack of friction will cause the torque to be ...

© 2016-2024 Copyright www.vwtouran.net | 0.0303