Volkswagen Touran Service Manual: Single Wire Seals, Installing
 Note
| Single wire seals prevent the penetration of water and dirt
into the contact housing. They are installed, for example, in
the engine compartment and must be reinstalled after a repair. |
| Single wire seal is crimped on at the factory together with
contact on the wire, this is not the case for repair wires.
Single wire seal must be slid onto wire first before crimping
the repair wire. |
| Single wire seals must always fit with the repair wire
cross-section. Outer circumference of single wire seal is
aligned according to chamber circumference of the contact
housing. Perform assembly using only the assembly tool with
correct fit. |
| Assembling Single Wire Seal |
|
|
|
| |
Release contact lock using assembly tool with correct fit
-A- and then pull wire with single
wire seal toward rear -arrow- out
of contact housing. |
|
|
|
| |
Cut off the old contact with single wire seal from the
vehicle-specific wiring harness. |
|
|
|
| |
Slide repair wire with new contact into corresponding
chamber of contact housing until it engages. |
|
|
|
| |
Put single wire seal -A- onto
free end of repair wire. |
Note
| When doing this, small diameter of single wire seal must
point toward contact housing. |
| |
Slide single wire seal -A- onto
repair wire up to the contact housing. |
|
|
|
| |
Slide single wire seal -A- into
contact housing until it stops using the corresponding assembly
tool -B-. |
|
|
|
| |
Shorten the repair wire and the vehicle-specific wiring
harness single wire as needed using the Wiring Harness Repair
Set - Wire Strippers -VAS1978/3-. |
| |
Crimp the stripped ends of repair wire and single wire of
vehicle-specific wiring harness using crimp pliers and a crimp
connection as described in chapter "Wire break with single
repair point". Refer to
→ Chapter "Wire Break with Single Repair Point". |
|
|
 |
First, open or release if necessary the secondary lock of
the contact housing. Refer to
→ Chapter "Contact Housings, Releasing and Disassembling".
...
Note
For technical reasons, the contact housing for the wire
terminals can be supplied only with the contacts p ...
Other materials:
Volkswagen Touran Owners Manual. Fitting the removable ball coupling
Fig. 106 Overview: removable
ball coupling
Fig. 107 In the rear bumper:
removing the cover of the towing bracket.
First read and observe the introductory information
and safety warnings The removable ball coupling is located
in the vehicle tool kit in the luggage compartment either ...
Volkswagen Touran Owners Manual. Introduction
This chapter contains information on the following subjects:
→ Function
When the toll card system is switched on and functioning,
tolls will be charged automatically when driving through a toll booth. The charge
will be confirmed by an audible signal. The charges will be g ...
© 2016-2024 Copyright www.vwtouran.net | 0.0063
Contacts in Contact Housing, Repairing
Contact Housings, Repairing Wire Terminals