VW Touran manuals

Volkswagen Touran Owners Manual: Starting the engine

First read and observe the introductory information and safety warnings

Step The actions should be carried out in the given order only.
1. Press the brake pedal. Keep it held down until stage 5 has been completed.
1 a. Vehicles with a manual gearbox: fully depress the clutch pedal until the engine has been started.
2. Select the neutral position or move the selector lever to P or N.
3. Only vehicles with diesel engines: to preglow, turn the vehicle key to position  . Indicator lamp  in the instrument cluster lights up.
4. Turn the vehicle key in the ignition lock to position   – do not depress the accelerator.
5. Release the vehicle key once the engine has started.
6. If the engine does not start, stop the procedure and repeat it after approximately one minute.
7. Release the handbrake if you wish to pull away   .

WARNING

Never leave the vehicle with the engine running. The vehicle could move suddenly, particularly if a gear is selected, and cause accidents and serious injuries.

WARNING

Start boosters could explode or cause the engine to suddenly rev.

NOTICE

Do not warm up the engine by running it with the vehicle stationary, but rather pull off as soon as you can see properly through the windows. This helps the engine reach operating temperature faster and reduces emissions.

Components with a high power consumption are switched off temporarily when the engine is started.

When starting from cold, the engine may be a little noisy for the first few seconds. This is quite normal, and no cause for concern.

At outside temperatures of less than +5° C (+41° F), fumes may be detected under the vehicle if the fuel pre-heater is switched on.

Ignition lock
Fig. 127 Vehicle key positions First read and observe the introductory information and safety warnings    Vehicle key     No ve ...

Switching off the engine
First read and observe the introductory information and safety warnings  Step The actions should be carried out in the given order only. 1. ...

Other materials:

Volkswagen Touran Owners Manual. Main beam control
First read and observe the introductory information and safety warnings Main beam control (Light Assist) The main beam control switches the main beam on and off again automatically within the limits of the system depending on environmental and traffic conditions as well as travelling ...

Volkswagen Touran Service Manual. Tires, Dismounting, Run-Flat Tires and Ultra High Performance Tires
Only trained personnel can perform the assembly work on run-flat tires and ultra high performance tires. If equipped check the tire pressure monitoring sensor with the vehicle diagnostic tester and if necessary replace. ...

© 2016-2024 Copyright www.vwtouran.net | 0.0063