Volkswagen Touran Service Manual: Threaded Connections, Repairing

Volkswagen Touran Service Manual / Electrical System / Wiring / Contact Surface Cleaning Set -VAS6410 / Threaded Connections, Repairing

Special tools and workshop equipment required

Torque Wrench 1331 5-50Nm -VAG1331-

Note

Do not use rust remover, contact spray or grease because the lack of friction will cause the torque to be exceeded when installing and this will lead to the threaded connection breaking.

The gray sanding pads are for slight contamination and suitable for "soft surfaces". The red sanding pads are for heavy contamination and suitable for "hard surfaces".

WARNING

Risk of injury. Follow all Warnings and Safety Precautions. Refer to → Chapter "Warnings and Safety Precautions".

Disconnect battery.

Loosen the cap nut and remove the wiring eyelet from the threaded connection.

Check the threaded connection for corrosion, contamination, etc.

Select the corresponding adapter and the corresponding sanding pad for the threaded connection.

Caution

Make sure the tin layer is not worn down too much and the copper is not visible. A galvanic element can form from this, destroying the metal and causing incorrect repairs.

Note

Due to the different thicknesses of the tin layer, the cleaning process must be performed in several steps and a visual inspection of the wiring eyelet between steps is necessary.

Place the adapter on the threaded connection and sand off the corrosion and contaminants with circular movements.

Check the threaded connection and sand it again if necessary.

Retighten the connection and, if necessary, the anti-rotation protection to the specified torque. Refer to → Wiring diagrams, Troubleshooting & Component locations.

Note

Optimal contact is ensured if the bolted components are tightened to the specified torque after cleaning.

Apply protection material to the threaded connection. Refer to → Chapter "Protecting".

Reconnect the battery.

WARNING

Risk of injury. Follow all Warnings and Safety Precautions. Refer to → Chapter "Warnings and Safety Precautions".

Reprogram the window regulators, enter the radio code, set the clock and, if necessary, code control modules that have error messages.

Wiring Eyelets, Repairing

Special tools and workshop equipment required Torque Wrench 1331 5-50Nm -VAG1331- Note Do not use r ...

Battery Terminal Clamp and Battery Terminal, Cleaning

Special tools and workshop equipment required Torque Wrench 1331 5-50Nm -VAG1331- The Contact Surface Cleaning Set -VAS6 ...

Other materials:

Volkswagen Touran Owners Manual. Headlight range control, instrument and switch lighting
Fig. 77 Next to the steering wheel: control for instrument and switch lighting ① and headlight range control ② First read and observe the introductory information and safety warnings ① Instrument and switch lighting When the headlights are switched on, the brightne ...

Volkswagen Touran Service Manual. Vehicle Diagnostic Tester, Connecting
Special tools and workshop equipment required Vehicle Diagnostic Tester Vehicle Diagnosis System - Diagnostic Cable -VAS5051/6A- (5 m) Vehicle Diagnosis System - Updated Cable - 3 ...