VW Touran manuals

Volkswagen Touran Service Manual: Tire Pressure Sensor and Metal Valve, Removing and Installing

Special tools and workshop equipment required
Torque Wrench 1410 -VAG1410- and Torque Wrench 1331 5-50Nm -VAG1331-
  Place metal valve with rubber seal through rim from inside.
  Attach chamfered washer and union nut from outside and tighten by hand.
  Tighten the union nut.
  Note
If equipped handle the glued-on wheel trim carefully. Surface slightly scratched.
Replace the damaged rim wheel trim.
1)  TPMS direct measuring. The wheel electronics are installed inside the wheel on the metal valve; the tire pressure and temperature values are transmitted and evaluated periodically.
2)  TPMS + indirect measuring. There are no wheel electronics installed inside the wheel. With the help of the ABS sensors, the TPMS compares the speed and rolling circumference of the individuals wheels. The loss of pressure is determined indirectly. If there is a change in the tire pressure, then the speed and the rolling circumference of wheel will also change.
3)  TPMS indirect measuring. There are no wheel electronics installed inside the wheel. With the help of the ABS sensors, the TPMS compares the rolling circumference of the individual wheels. The loss of pressure is determined indirectly. If there is a change in the tire pressure, then the speed of the tire will also change.
   
  Secure against turning with counterhold -1- (for example, a 2 mm drill bit).
  Note
If equipped handle the glued-on wheel trim carefully. Surface slightly scratched.
Replace the damaged rim wheel trim.
Tightening Specifications. Refer to → Anchor.
  Tire Pressure Sensor and Metal Valve, Removing and Installing
Tire Pressure Monitoring Sensor without Valve, Removing and Installing, Vehicle Before Customer Delivery
Special tools and workshop equipment required Torque Wrench -VAG1410- Perform the Following: Remo ...

Beru Wheel Electronics Tire Pressure Monitoring Sensor, Removing and Installing
Overview, Beru System   WARNING If tire sealant was used, then the wheel electronics on that particul ...

Other materials:

Volkswagen Touran Owners Manual. Turn signal and main beam lever
Fig. 75 Turn signal and main beam lever in the initial position. First read and observe the introductory information and safety warnings Move the lever into the desired position: Right turn signal. When the ignition is switched off, right parking light   . Left turn sig ...

Volkswagen Touran Owners Manual. Engine oil consumption
First read and observe the introductory information and safety warnings Engine oil consumption will be different from engine to engine and can change during the working life of an engine. Depending on how you drive and the conditions in which the car is used, oil consumption can be up to 1 ...

© 2016-2024 Copyright www.vwtouran.net | 0.0062