Volkswagen Touran Service Manual: Tires, Mounting, Wheels without and with Tire Pressure Monitoring System

Volkswagen Touran Service Manual / Wheel and Tire Guide Information / Tires, Mounting / Tires, Mounting / Tires, Mounting, Wheels without and with Tire Pressure Monitoring System

Only trained personnel can perform the assembly work on run-flat tires.

If equipped check the tire pressure monitoring sensor with the vehicle diagnostic tester and if necessary replace.

Bring the tires to the mounting temperature. Refer to → Chapter "Tires, Bringing to Mounting Temperature".

Note

When cleaning disc wheel (rim), the tire pressure monitoring sensor (if equipped) must not come into contact with water or be blown with pressurized air.

If equipped handle the glued-on wheel trim carefully. Surface slightly scratched.

Replace the damaged rim wheel trim.

Clean the rim.

Insert new tire valve with Valve Fitting Tool -VAS6459-.

Coat rim flanges, tire beads and inside of upper tire beads thoroughly with tire mounting paste.

Place the inner side of the tire on the rim.

Turn the rim until the tire valve of the tire pressure monitoring sensor aligns with the mounting head.

Push the tires between the tire valve or the tire pressure monitoring sensor and the mounting head into the bed in direction of -arrow-.

Let the tire dismounting/mounting machine run clockwise until the mounting head is in front of the tire valve or the tire pressure monitoring sensor. Slide the lower tire bead over the rim flange.

Turn the rim until the tire valve of the tire pressure monitoring sensor aligns with the mounting head.

Let the tire dismounting/mounting machine run clockwise until the mounting head is in front of the tire valve or the tire pressure monitoring sensor. Slide the upper tire bead over the rim flange.

Caution

There is a risk of damaging the rim due through too high spring pressure.

Never set the spring pressure over 3.3 bar (47.86 psi).

Inflate the tire to maximum pressure of 3.3 bar (47.86 psi) (spring pressure).

If tire beads do not make contact completely on disc wheel edge, then release air, press off tire bead once more and coat rim flange thoroughly again with tire mounting paste.

When the tire bead makes contact on the bead seat, increase the pressure to 4 bar (58 psi).

If the tire bead does not make complete contact with the bead seat, dismount the tire and mount it again. Refer to → Chapter "Tires, Dismounting, Wheels without and with Tire Pressure Monitoring System".

Turn the valve insert.

Fill the tire with the specified tire pressure.

Balance the tire. Refer to → Chapter "Wheel, Balancing".

Note

Avoid strong braking or acceleration maneuvers during the first 100 to 200 km (62.13 to 124.27 miles). Otherwise due to the tire mounting paste the tires can distort on the rim.

Tires, Mounting

...

Tires, Mounting, Run-Flat Tires and Ultra High Performance Tires

Only trained personnel can perform the assembly work on run-flat tires and ultra high performance tires. If equipped check the tire pressure mo ...

Other materials:

Volkswagen Touran Owners Manual. Using the cruise control system
Fig. 153 On the left of the steering column: button and switch for the CCS (vehicles without Lane Assist) Fig. 154 On the left of the steering column: operating lever for the CCS (vehicles with Lane Assist) First read and observe the introductory information and safety warnings Operating ...

Volkswagen Touran Owners Manual. Warning lamp
First read and observe the introductory information and safety warnings Lit up Possible cause Correction Fault in the alternator. Go to a qualified workshop. Have the electrical system checked. Switch off all electrical e ...