Volkswagen Touran Owners Manual: Indicator lamps

Volkswagen Touran Owners Manual / Before the journey / Lights and vision / Lights / Indicator lamps

First read and observe the introductory information and safety warnings

Lit up	Possible cause	Correction
	Vehicle lighting not working partially or completely.	Change the corresponding bulb or if all bulbs are functioning, go to a qualified workshop.
	Bend lighting fault.	.
	Rear fog light switched on.	.
	Fog lights switched on.	.
	Turn signal for the right or left. The indicator lamp will flash twice as fast if one of the turn signals on the vehicle or trailer is not working.	If necessary, check the vehicle lights and lights on the trailer.
	Main beam is switched on or the headlight flasher is being operated.	.
	Main beam control (Light Assist) or automatic main beam control (Dynamic Light Assist) is switched on.	.

Several warning and indicator lamps will light up briefly when the ignition is switched on while the vehicle runs functional checks. They will switch off after a few seconds.

WARNING

Failure to observe the warning lamps and text messages could lead to your vehicle breaking down in traffic, accidents and serious injuries.

Never ignore warning lamps and text messages.

Stop the vehicle as soon as it is possible and safe to do so.

Stop the vehicle at a safe distance away from moving traffic and so that no part of the exhaust system can come into contact with any inflammable material underneath the vehicle, e.g. dry grass, fuel, oil etc.

A broken-down vehicle increases the risk of accidents – both for you and other road users. If necessary, switch on the hazard warning lights and set up the warning triangle in order to warn other road users.

NOTICE

Failure to observe the warning lamps and text messages could lead to your vehicle being damaged.

Introduction

This chapter contains information on the following subjects: → Indicator lamps → Turn signal and main beam lever → Switching lights on and off & ...

Turn signal and main beam lever

Fig. 75 Turn signal and main beam lever in the initial position. First read and observe the introductory information and safety warnings Move the lever into the desired position: Rig ...

Other materials:

Battery, Charging with Battery Charger -VAS5903
Special tools and workshop equipment required Battery Charger -VAS5903- WARNING Risk of injury. Follow all Warnings and Safety Precautions. Refer to → ...

Wear Spots
A wear spot is a flat spot on the tread of the tires that can be caused by extreme braking maneuvers on subsurface such as asphalt. At the same time a tire during the braking maneuver is rubbed at selective points which causes a ti ...

Stone Chip Protection -AKR 311 KD1 05
Definition: Stone Chip Protection -AKR 311 KD1 05-, black Edition 04/2009 Product Description Stone Chip Protection -AKR 311 KD1 05- is a finely atomizing coating material wi ...