Volkswagen Touran Owners Manual: Indicator lamps

Volkswagen Touran Owners Manual / Cleaning and maintenance / Vehicle care and maintenance / Engine management system and exhaust purification system / Indicator lamps

First read and observe the introductory information and safety warnings

Lit up	Possible cause	Correction
	Engine management system malfunction (Electronic Power Control).	The engine should be checked by a qualified workshop as soon as possible.
	Diesel engine pre-glow before starting the engine.
	Fault in catalytic converter.	Decrease speed. Drive carefully to the next qualified workshop. Have the engine checked.
	Diesel particulate filter has become saturated with soot.	Drive for approximately 15 minutes in 4th gear (manual gearbox) or select D (automatic gearbox) at a speed of at least 70 km/h (45 mph). Please observe any valid speed limits . Go to a qualified workshop if the indicator lamp still does not go out.

Flashes	Possible cause	Correction
	Fault in engine management system (diesel engine).	The engine should be checked by a qualified workshop as soon as possible.
	Misfiring which damages the catalytic converter.	Decrease speed. Drive carefully to the next qualified workshop. Have the engine checked.

Several warning and indicator lamps will light up briefly when the ignition is switched on while the vehicle runs functional checks. They will switch off after a few seconds.

WARNING

Please observe legal requirements if cleaning the diesel particulate filter when in traffic.

Follow driving recommendation only if visibility, weather, road and traffic conditions are suitable.

Do not endanger other vehicles on the road.

NOTICE

To avoid damage to your vehicle, always observe the indicator lamps and associated warning texts.

If the indicator lamps

are lit up, fuel consumption may be higher and engine performance reduced.

Introduction

This chapter contains information on the following subjects: → Indicator lamps → Catalytic converter → Diesel particulate filter Additional information and wa ...

Catalytic converter

First read and observe the introductory information and safety warnings The catalytic converter is used for exhaust gas post-treatment and helps to reduce exhaust emissions. Observe the follow ...

Other materials:

Volkswagen Touran Service Manual. Battery Terminal Clamp and Battery Terminal, Cleaning
Special tools and workshop equipment required Torque Wrench 1331 5-50Nm -VAG1331- The Contact Surface Cleaning Set -VAS6410- makes optimal repair quality possible in the realm of vehicle electronics. Using th ...

Volkswagen Touran Service Manual. A/C Compressor with A/C clutch
Caution Non-approved tools or materials such as leak sealing additives can cause damage or malfunctions in the system. Only use tools and materials approved by the manufactu ...