Volkswagen Touran Service Manual: Release Tool Set -VAS1978/35

Volkswagen Touran Service Manual / Electrical System / Wiring / Wiring Harness and Connector Repairs / Release Tool Set -VAS1978/35

The Release Tool Set -VAS1978/35- is used to release the various primary and secondary locking mechanisms on VW-group vehicles. The set consists of 26 different tools which can be used to professionally release or assemble e.g. round connector systems, flat terminals with one or two locks as well as single wire seals.

The allocation of the correct release tools to the respective locking mechanisms can be found in the table in the Release Tool Set -VAS1978/35- Operating Instructions.

Wiring Harness Repair Set -VAS1978A

The new Wiring Harness Repair Set -VAS1978A- makes optimal repair quality possible in the realm of vehicle electronics. Using the new pliers, repairs affecting harnes ...

Crimping Pliers with Insert

The Crimping Pliers without Insert -VAS1978/1- with Crimping Pliers - Insert 2 -VAS1978/2- is a component of the Wiring Harness Repair Set -VAS1978- and is used to cr ...

Other materials:

Volkswagen Touran Owners Manual. Introduction
This chapter contains information on the following subjects: → Ignition lock → Starting the engine → Switching off the engine → Electronic immobilizer → Engine pre-heating Immobilizer display If the vehicle key is not valid or the ...

Volkswagen Touran Service Manual. O-Ring
Caution Non-approved tools or materials such as leak sealing additives can cause damage or malfunctions in the system. Only use tools and materials approved by the manufactu ...