Volkswagen Touran Service Manual: Refrigerant Circuit, Flushing
 Note
| For vehicles in which no adapters fit on to the refrigerant
pipes, for example, a blower pistol with rubber mouthpiece is to
be used to blow through individual components. Special care must
be taken not to damage the connections (crushing or scratching). |
| Evaporator is to be flushed via the connection for
low-pressure pipe (large diameter) after removing expansion
valve or removing restrictor. |
| Always flush components in direction opposite of refrigerant
flow direction.
|
| Check expansion valve and replace if dirty or corroded. |
| If there are dark, sticky deposits in the components that
cannot be removed with compressed air, replace these components. |
| Thin, light grey deposits on the insides of refrigerant
pipes do not impair the function of the components. |
| After flushing, always replace receiver/dryer or reservoir
and restrictor. Replace dryer cartridge or dryer on condensers
with attached dryer. |
|
|
|
In order to be able to force moisture and other contaminants
out of refrigerant circuit, compressed air and nitrogen (to
force moisture out of refrigerant circuit) ar ...
Other materials:
Volkswagen Touran Owners Manual. Correct sitting position
Fig. 37 There must be a distance
of at least 25 cm between the driver and the steering wheel
Fig. 38 Correct seat belt
routing and head restraint adjustment
First read and observe the introductory information
and safety warnings The following points describe the
correct sitting pos ...
Volkswagen Touran Owners Manual. Engine pre-heating
Fig. 128 The front left-hand side of the
bumper: cover ① and connecting socket ② for engine pre-heating
First read and observe the introductory information
and safety warnings For the engine pre-heating mode, the engine coolant is
heated slowly using a heating element while the vehicle ...
© 2016-2025 Copyright www.vwtouran.net | 0.007
General Information