Volkswagen Touran Service Manual: Vehicle Pulls to One Side

Volkswagen Touran Service Manual / Wheel and Tire Guide Information / Handling Problems / Vehicle Pulls to One Side

General Information

Perform a road test to determine if a vehicle pulls to one side and if so, when and to which side. If the vehicle pulls to one side. Refer to → Chapter "Corrective Action When Vehicle Pulls to One Side".

If the vehicle alignment is measured, submit the measurement printout and the complaint report with the tire.

Manufacturer's tolerances can lead to taper in the tire construction. This results in a side force when the tire rolls, which acts directly on the suspension and can therefore lead to vehicle self-steering behavior. Targeted rotation of the wheels can balance out this self-steering behavior.

Wear Spots

Wear spots are caused by a hard stop with locked wheels whereby the rubber compound is abraded from the contact patch. When the tires slide across th ...

Taper

Taper is caused by slightly offsetting the tread and/or the belt by a few tenths of a millimeter from the geometric center of the tire. Taper cannot be recognized vis ...

Other materials:

Oxygen Sensor Unit Protective Pipes
Note In addition to using the part number, the protective pipe can also be used for identification. Version D1, 6 openings, 3.5 mm each Only used with the 4-pin oxygen sen ...

Turn signal and main beam lever
Fig. 75 Turn signal and main beam lever in the initial position. First read and observe the introductory information and safety warnings Move the lever into the desired position: Right turn signal. When the ignition is switched off, right parking light . Left turn sig ...

Frontal collisions and the laws of physics
Fig. 52 Passengers of a vehicle heading for a brick wall. They are not wearing seat belts Fig. 53 A vehicle with unbelted occupants strikes the wall First read and observe the introductory information and safety warnings The physical principles involved in a frontal collision are r ...