Volkswagen Touran Owners Manual: Checklist

Volkswagen Touran Owners Manual / If and when / Practical tips / Changing bulbs / Checklist

Always carry out the following actions for changing a bulb in the given order :

Park the vehicle on a flat and solid surface at a safe distance from the flow of traffic.
Apply the handbrake Braking, stopping and parking Brakes Parking .
Turn the light switch to position 0 Lights Lights .
Shift the turn signal lever to the neutral position Lights Lights .
Automatic gearbox: move the selector lever to position P Changing gear Changing gear Automatic gearbox see Automatic gearbox_0 Automatic gearbox see Changing gear_0 Automatic gearbox Manual gearbox see Changing gear_0 Manual gearbox .
Stop the engine and remove the key from the ignition Starting and stopping the engine Engine and ignition Ignition see Engine and ignition_0 .
Manual gearbox: select a gear Changing gear Changing gear Automatic gearbox see Automatic gearbox_0 Automatic gearbox see Changing gear_0 Automatic gearbox Manual gearbox see Changing gear_0 Manual gearbox .
Switch off the orientation lighting Lights Lights .
Leave the defective bulbs to cool down.
Check to see if a fuse has blown Fuses Fuses .
Follow the instructions to change the affected bulb . Always use identical bulbs with the same designation. The designation is inscribed on the bulb, either on the glass part or on the base.
Do not touch the glass part of the bulb with unprotected fingers. The heat of the bulb would cause the fingerprint to evaporate and condense on the reflector. This will impair the brightness of the headlight.
After changing the bulb, check to make sure that the bulb is working properly. If the bulb is not working properly, the bulb may not have been inserted properly or may have failed again, or the connector may have been inserted incorrectly.
Each time you change a bulb in the front of the vehicle, have the headlight settings checked by a qualified workshop.

WARNING

Ignoring any of the points on this important safety checklist can lead to accidents and severe injuries.

Follow the instructions in the checklist and observe the general safety procedures.

NOTICE

Always take care when removing or fitting lights to prevent damage to the paintwork or to other vehicle parts.

Information on changing a bulb

First read and observe the introductory information and safety warnings ...

Changing bulbs in the front headlights

Fig. 216 In the engine compartment: covers on the left front headlight Ⓐ Dipped beam headlight, Ⓑ Turn signal, Ⓒ Daytime running light and main beam headlight and Ⓓ Side light in the case ...

Other materials:

Volkswagen Touran Owners Manual. Locking the front passenger door and rear doors manually
Fig. 192 In the end face of the front right-hand door: manual lock covered by a rubber seal Fig. 193 Manually locking the vehicle with the vehicle key First read and observe the introductory information and safety warnings The front passenger door and the rear doors can be locked manua ...

Volkswagen Touran Service Manual. Fold Corrosion Servicing Notes
Corrosion on the Fold Edges, for Instance on the Hood, Door or also the Rear Lid Remove the corroded areas with → Chapter "Pneumatic Brush Grinder Set -VAS6446-" or → Chapter "Brush Grinder Set -VAS6776- ...