Volkswagen Touran Owners Manual: Introduction

Volkswagen Touran Owners Manual / If and when / Practical tips / Hub caps / Introduction

This chapter contains information on the following subjects:

→ Centre covers

→ Wheel cover

→ Wheel bolt caps

Additional information and warnings:

Cleaning and caring for the vehicle exterior

Vehicle tool kit

Changing a wheel

Breakdown set

WARNING

Using unsuitable hub caps and fitting the hub caps incorrectly could cause accidents and serious injuries.

Hub caps which are not fitted properly could become loose while the vehicle is in motion and endanger other road users.

Do not use damaged hub caps.

Always ensure that the flow of air to cool the brakes is not restricted or reduced. This also applies to the retrofitting of wheel trims. If the flow of air is not sufficient, the braking distance could increase significantly.

NOTICE

Remove hub caps carefully and fit them again properly so as to avoid damage to the vehicle.

Centre covers

Fig. 202 Removing the centre covers by pulling Fig. 203 Removing the centre covers by turning First read and observe the introductory information and safety warnings Depending on the desig ...

Other materials:

Volkswagen Touran Owners Manual. Using the vehicle in other countries and continents
First read and observe the introductory information and safety warnings In the factory, the vehicle is produced specifically for a certain country and complies with this country's registration regulations valid at the time of vehicle production. If the vehicle is going to be sold in anothe ...

Volkswagen Touran Owners Manual. After changing a wheel
First read and observe the introductory information and safety warnings If needed, clean the tools then place them back in the foam rubber holder in the luggage compartment or behind the side trim on the left-hand side of the luggage compartment Stow the spare wheel, temporar ...