Volkswagen Touran Service Manual: Maintenance Test, Performing

Volkswagen Touran Service Manual / Electrical System / Battery, Starter, Generator, Cruise Control / Battery, Checking / Maintenance Test, Performing

WARNING

Do not check or charge batteries that have a visual indicator that is bright yellow. Jump starting must not be used!

There is a risk of explosion during testing, charging or jump starting.

These batteries must be replaced.

Select "Maintenance Test".

Connect the scanner.

Note

If there is no scanner, manually enter the VIN on the printed test results.

Scan the VIN.

Select "at the battery pole" or "at the battery jump start terminal".

Scan in the battery 2D code or manually select the type and manufacturer in the menu.

Measure the temperature. Hold the temperature sensor approximately 5 cm above the terminal connection until the temperature is stable.

Start the test.

Print out the test report if necessary.

Warranty Test, Performing

WARNING Do not check or charge batteries that have a visual indicator that is bright yellow. Jump starting must not ...

Service Test, Performing

Note The printed test results can differ depending on the software version. Read the Battery Tester -VAS6161- Operating In ...

Other materials:

Volkswagen Touran Owners Manual. Introduction
This chapter contains information on the following subjects: → Running-in → Accessories and parts → Service fluids and consumables → Repairs and technical modifications → Repairs and faults in the airbag system → Retrofitti ...

Volkswagen Touran Owners Manual. Running-in
First read and observe the introductory information and safety warnings Please follow the regulations concerning running-in of new parts. Running in a new engine A new engine needs to be run in during the first 1,500 km. During its first few hours of running, the internal friction in the e ...