Volkswagen Touran Owners Manual: Opening or closing the panoramic sliding roof
Fig. 34 In the roof: turn the switch to open and close
Fig. 35 In the roof: push and pull the switch to tilt and close
First read and observe the introductory information
and safety warnings In order to tilt the panoramic sliding roof, the rotary switch must be in position .
| Function | Position of switch | Action |
|---|---|---|
| Open sliding roof completely: | Ⓒ | Turn the switch to the desired position. |
| Move sliding roof to convenience position: | Ⓑ | |
| Close sliding roof completely: | Ⓐ | |
| Tilt the tilting roof completely: | Ⓓ | Push the switch back briefly (arrow). |
| To stop the one-touch function: | Ⓓ or Ⓔ | Press or pull switch again briefly. |
| Close tilting roof completely: | Ⓔ | Pull the switch back briefly (arrow). |
| To set an intermediate position: | Ⓓ or Ⓔ | Hold the switch pushed or pulled back until the roof reaches the desired position. |
The panoramic sliding roof will work only when the ignition is switched on. The panoramic sliding roof can be operated several minutes after the ignition has been switched off, provided the driver door and front passenger door are not opened.
Introduction
This chapter contains information on the following subjects:
→ Opening or closing the panoramic sliding roof
→ Opening or closing the sun blind
→ ...
Opening or closing the sun blind
Fig. 36 In the roof: buttons
for the sun blind
First read and observe the introductory information
and safety warnings
Function
Action
T ...
Other materials:
Volkswagen Touran Owners Manual. Engine pre-heating
Fig. 128 The front left-hand side of the
bumper: cover ① and connecting socket ② for engine pre-heating
First read and observe the introductory information
and safety warnings For the engine pre-heating mode, the engine coolant is
heated slowly using a heating element while the vehicle ...
Volkswagen Touran Service Manual. General Information
In order to be able to force moisture and other contaminants
out of refrigerant circuit, compressed air and nitrogen (to
force moisture out of refrigerant circuit) are to be used.
For the most part, blowing through the refrigerant circui ...
