Volkswagen Touran Service Manual: Releasing and Disassembly Contact Housings, General Information
 Note
| Observe general notes for repairs on the vehicle electrical
system. Refer to
→ Chapter "Vehicle Electrical System, General Repair
Information". |
| Always use the release tools intended for the releasing
process. Under no circumstances may terminals be pulled
forcefully out of terminal housings. |
| Damaged contact housings must always be replaced. New
contact housings may be ordered via OTC Kassel. |
| Small screwdrivers may be used as an aid to release the
secondary locks. |
| Chamber/pin assignment is located partially stamped in on
secondary lock or rear side of terminal housing. |
| Detailed information on component locations of harness
connectors. Refer to
→ Wiring diagrams, Troubleshooting & Component locations. |
| The allocation of the correct release tools to the
respective locking mechanisms can be found in the table in the
Release Tool Set -VAS1978/35- Operating Instructions. |
|
|
|
Note
For technical reasons, the contact housing for the wire
terminals can be supplied only with the contacts p ...
The secondary lock is a housing securing mechanism (second
locking mechanism) that secures all wires in one contact
housing. If a secondary lock is installed at a con ...
Other materials:
Volkswagen Touran Owners Manual. Cleaning wheels
First read and observe the introductory
information and safety warnings Cleaning steel wheels
Use an industrial cleaner to remove brake dust. Steel wheels should therefore
be cleaned regularly with a separate sponge.
Any damage to the paint on steel wheels should be touched up before the me ...
Volkswagen Touran Owners Manual. Wheel bolt caps
Fig. 205 Removing the wheel bolt caps
First read and observe the introductory information
and safety warnings
Take the wire hook from the tool kit .
Insert the hook through the opening in the cap and pull off in the direction
of the arrow.
The caps protect the wheel b ...
© 2016-2026 Copyright www.vwtouran.net | 0.0104
