Volkswagen Touran Service Manual: Wiring Harness and Connector Repairs
- Vehicle Electrical System, General Repair Information
- Wiring Harness Repair Set -VAS1978-
- Upgrade Kit For VAS1978 -VAS1978/50
- Wiring Harness Repair Set -VAS1978A
- Release Tool Set -VAS1978/35
- Crimping Pliers with Insert
- Contact Release Tools
- Single Wire Seal Assembly Tools
- Wiring Harness Repair Set - Wire Strippers -VAS1978/3
- Wiring Harness Repair Set - Hot Air Blower -VAS1978/14A
- Crimping Pliers - .35-2.5mm -VAS1978/1A
- Airbag and Belt Tensioner Wire Repair Information
- CAN Bus Wires, Repairing
- Antenna Wires, Replacing
- Wires with Cross Section up to 0.35 mm 2, Repairing
- Wire Break with Single Repair Point
- Wire Break with Dual Repair Point
- Fiber-Optic Cable, Assembling
- Fiber-Optic Cable, Disconnecting from Wiring Harness Connector
- Aerial Cable Repair Set -VAS6720-
- Contact Housings and Connectors, Repair Information
- Contacts in Contact Housing, Repairing
- Single Wire Seals, Installing
- Contact Housings, Repairing Wire Terminals
- Releasing and Disassembly Contact Housings, General Information
- Secondary Lock
- Primary Lock
- Round Connector Systems
- Flat Connector Systems
- Special Connector Systems
Vehicle Diagnostic Tester, Connecting, Golf MY 1998 through 2003
Apply the parking brake.
In vehicles with automatic transmission, move the selector
lever to the "P" or "N" position.
...
Vehicle Electrical System, General Repair Information
Caution
Follow the procedure in the repair manual when
disconnecting and connecting the battery.
...
Other materials:
Volkswagen Touran Owners Manual. Manual gearbox: selecting a gear
Fig. 131 Gear shift pattern of a 6-speed
manual gearbox
First read and observe the introductory information
and safety warnings The positions of the individual driving gears are shown
on the gearshift lever .
Fully depress and hold the clutch pedal.
Move the gearshift lever t ...
Volkswagen Touran Service Manual. Wheel, Balancing, Tire and Wheel Radial and Lateral Run-Out, Checking
Before beginning balancing, the following requirements must
be fulfilled.
The tire pressure must be OK.
The tire profile must not be worn on one side. The tire
profile must be at least 4 mm.
...
