Volkswagen Touran Service Manual: Refrigerant Circuit Component Arrangement

Caution
| Non-approved tools or materials such as leak sealing
additives can cause damage or malfunctions in the
system. |
| Only use tools and materials approved by the
manufacturer. |
| The warranty is voided if non-approved tools or
materials are used. |
|
| All components of the refrigerant circuit submitted for
quality observation are always to be sealed (use original
sealing caps of original part). |
| Replace damaged or leaking components of refrigerant
circuit. Refer to
→ Chapter "Components, Replacing". |
| To date, the original parts (compressor, reservoir,
receiver/dryer, evaporator and condenser) have been filled with
nitrogen gas. This charge is being gradually discontinued. There
is little or no pressure equalization when removing the sealing
plugs from the original part. |
| High pressure side are the condenser, receiver/dryer and
restrictor or expansion valve to separate the high and low
pressure liquid ends. |
| High pressure results from the restrictor or expansion valve
forming a constriction and causing the refrigerant to
accumulate, thus leading to an increase in pressure and
temperature. |
| Excess pressure results if too much refrigerant or
refrigerant oil is used, the condenser is contaminated, the
coolant fan is malfunctioning, the system is blocked or if there
is moisture in the refrigerant circuit (the restrictor or
expansion valve freezes). |
| Low pressure side are the evaporator, reservoir, evaporator
temperature sensor and compressor to separate high and low
pressure gas ends. |
| A drop in system pressure can occur due to loss of
refrigerant, restrictor or expansion valve (restriction not
given), A/C compressor malfunction or iced evaporator. |
|
|
|
Caution
Non-approved tools or materials such as leak sealing
additives can cause damage or malfunctions in the
sys ...
Other materials:
Volkswagen Touran Owners Manual. Engine pre-heating
Fig. 128 The front left-hand side of the
bumper: cover ① and connecting socket ② for engine pre-heating
First read and observe the introductory information
and safety warnings For the engine pre-heating mode, the engine coolant is
heated slowly using a heating element while the vehicle ...
Volkswagen Touran Owners Manual. Fitting the front towing eye
Fig. 227 Front bumper, right-hand side:
screwing in the towing eye
First read and observe the introductory information
and safety warnings The towing eye is screwed into a threaded hole on the
right of the front bumper .
The towing eye must always be kept in the vehicle.
Observe the ...
© 2016-2026 Copyright www.vwtouran.net | 0.023
